9.5\" Fan Clutch Rebuild Kit

Kit Masters Part #
9500HP

The 9500HP fan clutch rebuild kit by Kit Masters combines superior materials and advanced innovations making it the easy choice for rebuilding Horton® HT/S®-style fan clutches.

2 Year/200,000 Mile Warranty



Find a place to buy ›

 

Premium Materials

Kit Masters’ 9500HP kit features vastly improved materials, compared to the OEM. Our Viton® o-rings withstand temperatures up to 400° and resist drying out. Dramatically stronger friction material sustains more fan clutch engagements and will not shear away from the backing plate.

 
 


 
 

Two Bearing Hub

The splined hub assembly in HT/S fan clutches must absorb the radial load from the fan belts and the axial load from the fan blade. Kit Masters’ dual bearing splined hub assembly transfers more of the load further down the fan clutch shaft to reduce wear on the front bearing. This equals extended fan clutch life.

 
 

Replaces OEM Part #:

994305, 994322, 994388, 994336, 601158, 994389, 894305,

 


 

FAQs

+What is the difference between a 7500HP and 9500HP?

A 7500HP is a complete rebuild kit to rebuild a Horton® HT/S style fan clutch that has a 7.5” outside diameter friction material. A 9500HP is a complete rebuild kit to rebuild a Horton® HT/S style fan clutch that has a 9.5” outside diameter friction material.


+What is the difference between a 9500H and a 9500HP?

A 9500HP is a complete rebuild kit to rebuild a Horton® HT/S style fan clutch that has a 9.5” outside diameter friction material. A 9500H rebuild kit is a 9500HP rebuild kit minus the 9.5” friction plate.


+I just installed a 7500HP or 9500HP. Why won't it disengage?

When you were rebuilding your fan clutch, you most likely did not use the red spacer, which is included in the journal spacer packet. Disassemble your fan clutch until you get down to the journal spacer. Place the red spacer on top of the journal spacer and re-assemble the rest of the fan clutch again. When correctly rebuilt, and with no air line connected, the friction plate should not be in contact with the friction material.


+Why is air leaking out of the hole on the front/pilot of my fan clutch?

The carbon material on your air cartridge is not mating correctly against the face seal that is threaded into the air chamber cap. Inspect the face seal and the carbon on the air cartridge. Look for any cracks or chips. Replace the air cartridge if needed.


+Why is air leaking out of the fuse port on the front of the friction plate?

There has been excessive heat from the friction plate wearing on the friction, causing the fuse to melt, creating an air leak. This is a preventative measure telling the truck owner that the truck needs to be serviced. Check your air supply pressure to make sure that there is a minimum of 90 psi, right at the entry point of the fan clutch. You can rebuild your fan clutch with a seal kit to replace the damaged seals and fuse once the air supply issue is fixed. You may choose to completely rebuild your fan clutch as well.